Multiple EtherLynx Camera Systems

FinishLynx has the ability to manage multiple EtherLynx cameras at the same time. These cameras can be used on the same finish line, or on different split or finish lines, and each camera can be toggled in or out of capture mode for each event.

Overview

The software can be custom configured to split the Image Zone into separate “panes” for each camera.

A camera can be displayed in one or more of the designated “panes” at any of the available zoom settings. The advantage of this feature is that an operator can view - simultaneously - an overall view of the finishers of an event, a close up of individual finishers from the same camera, and a reverse angle from a second camera.

Multiple Camera Views

Figure: Multiple Camera Systems

note: On a multi-camera network, all cameras transfer images on separate threads, making image transfer faster and less prone to delays caused by slower, older cameras.

How to set up two cameras on the same finish line?

It is logical to think that the rules for setting up a two camera system would not be any different than setting up a single camera system. This is largely true, but having a second camera allows more flexibility in the way they are set up.

As an example, when using two cameras, it is more common to set up the inside camera at slightly less than the recommended angle. This means it can be closer to the ground, or further from the edge of the track. What this does is increase the size of individuals finishing nearer the camera, and thus the likelihood of reading a hip number.

How to control multiple cameras?

There are independent controls for each of the cameras in a multi-camera system. The Camera Settings can be set to be different values for each camera.

In order to capture image from more than one camera at the same time, they must all be connected to the computer when the software is started. It is then a simple matter of changing the relevant Capture settings to read “Yes” in the Hardware Control window.

The cameras that are active for an event are listed in the Information Zone.

If a camera name and information appears in red in the Hardware Control window, the camera is not communicating to the software. Check all connections to the camera - power, Ethernet, etc...

note: FinishLynx determines which cameras are connected when the software loads. If a camera is not connected or is not being recognized, the software will not allow the user to capture from it.

How to select the image pane for each camera?

When a new Event is created, FinishLynx will create an image pane for the first two cameras set to capture in the Camera Listing of the Hardware Control window.

  • To change the image pane assignment:
  1. Right-click on a camera name in the Information Zone. The image pane pop-up appears.
  2. Click to select the image pane for this camera.
  • Selecting an image pane that is currently used by another camera will override the setting with the selected camera.
  • The same camera can be set for all three image panes at the same time.

Figure: Multiple Camera Systems

note: To retain the image pane selection for the next new Event, Templates can be used.

How to show the hash line on all image panes?

The hash line can be configured to appear and move in all image panes while it is being positioned in another, by using the Time Tracking setting.

  • To enable time tracking for all cameras.
  1. Click Image | Options...
  2. Click to select Time Tracking: All cameras.
  3. Click Ok.
  4. Click to place the hash line on an EtherLynx image pane.
  • The hash line will also appear in other viewable image panes at the same time-indexed location.

tip: To have the hash line track only on other views of the same camera, select Time Tracking: Same Camera.