Record Times & Save
Where to position the hash line?
In order to determine order of finish and times, it is necessary to have a way of comparing the relative position of the finishers and knowing at what time the relevant part of the competitor broke the plane of the finish line.
Different sports use different parts of the competitor as the critical component for timing purposes:
- Track and Field - the torso.
- Cycling - the front edge of the bicycle wheel.
- Horse Racing - the nose of the horse.
- Speed Skating - the tip of the skate.
- Canoeing and Rowing - the front of the boat.
- Motorsports - the front edge of the object.
- Downhill and Nordic Skiing - the tip of the boot.
How to move the hash line?
- To move the hash line at the required position:
- Left-click and hold in an image pane.
- Move the mouse to the correct position.
- Release the mouse button.
- The time for this competitor’s finish will show up in the Finish Time Box.
tip: Use the LEFT & RIGHT buttons on the keyboard to fine tune the hash line position.
Finish Time Box
Figure: Record Times & Save
How to record a time?
- Three simple steps are required to record a time:
- Position the hash line After you have positioned the hash line and released the mouse button, an I-beam cursor will automatically start flashing in the ID Box - which is located between the Finish Time Box and the ID Mode icon.
- Enter the identification information This should match the competitors information in the Results Zone based on the selected ID Mode (lane number, ID number, license number or nothing).
- Press the Enter key Depending on the mode you have chosen to identify the competitors, the information you type in the ID Box will appear in the relevant area of the Results Zone.
Sample Results Zone
Figure: Record Times & Save
note: If you try to enter information for a competitor who does not appear in the start list, FinishLynx will alert you by presenting you with a dialog box asking if the information you have entered is correct.
note: Because the computer has no way of knowing which competitor you chose to begin evaluating the image, the ranking in the Place column will not necessarily be accurate until the whole picture has been read - unless you read from first place, in order, back to last place.
note: The only exception to this is if you have chosen Identify by Nothing; in this case the only thing you need to do to record a finisher’s time in the Results Zone is to hit Enter after you have positioned the hash line in the correct position.
How to read close races?
When reading a close race, FinishLynx will often place one participant ahead of another even though they appear to have the same time in the Time column of the Results Zone. This is because FinishLynx always uses its ability to time to 1/10,000th to determine order of finish.
There are a few safety features built in, however, to prevent the FinishLynx operator from inadvertently picking a race incorrectly. If a time is read which places a participant close to an already entered finisher, the system will warn the operator. This allows closer investigation of the situation and ensures that the race was chosen as expected. It also prevents accidentally reading the same finisher twice.
FinishLynx will allow dead heats; if two participants finish in the same line of the image, they will be given the same place as well as the same time. This could happen, for example, if the finishers are within 1/1000th of a second and the image was being taken at 1000 frames per second.
How to save the event?
When an event is saved, the start, image and results are also saved. The event can be opened at a later time to verify or print information.
- To save an event:
- Click File | Save... from the Menu Bar.
- (Optional) Rename the file.
- Click save.
- Two different file types are saved with an event:
- *.evn .evn files include all the events information other than the image.
- *.i0[#] There is a .i0[#] file for each camera enabled to capture image.
note: When opening an event, only the .evn files appear. Opening this file type will automatically load related .i01 files.