Motorsports - Key Steps

Camera Alignment and Field of View (More Info)

Mount and align the camera in the plane of finish line

Manually control the geared head for gross movements and fine tune with the remote positioner. Cameras MUST be perfectly level HOW TO CENTER A REMOTE POSITIONER? Check out these Camera Alignment Tools: Smart Zoom in 2D Align mode Electronic ViewFinder (EVF) Set colors using white-balance. Set Capture - Object Active Area.

Set field of view

Rule of thumb - the field of view should be limited to the maximum height of the finish line required to be captured. Zoom in as much as possible to avoid dead space.

Watch the video

Adjust Focus

Use Automatic Exposure Control (AEC) to temporarily limit depth of field. Use Focus Helper - select region to optimize for racing line.

Image Quality Optimization (More Info)

Camera Settings vs FinishLynx Options

  • LDP = Camera Settings (independent for each camera)
  • LDP != Options (no post-processing)

Camera Settings - Setup tab

Figure: Motorsports - Key Steps

note: Green box = set and forget; Yellow box = adjust at each event ( = settings for events under low light)

  • Level = always aim for 0.0
  • Name = free-text to identify cameras (linked to hardware)
  • Image Orientation - must be set based on direction of travel in relation to each camera location. If the camera is “seeing” objects moving < < < < in front of the lens, set your Image Orientation to Left; if it sees them moving > > > >, set it to Right.
  • White Balance - Procedure
  • Gamma - values less than one increase the difference between similar dark pixels in the image, which expands dynamic range within darker areas of the image. Particularly useful in back lit conditions. (default = 0.70).
  • Black Level - increasing this value re-balances the dynamic range, particularly in low light conditions when highlights seem overexposed (blooming) and darker parts of the image seem underexposed (tend to greenish black). This setting needs to be used prudently; if increased excessively, it will add unwanted pinkish mask to the image that may severely affect AGC functionality. Increase in small increments (2-5) in low light when the darks appear greenish/black and highlights are blooming (default = 0; max = 20).
  • Phase Light Comp. - reduces the vertical dark bars in the image caused by artificial light.

Camera Settings - Parameters tab

Figure: Motorsports - Key Steps

note: Green box = set and forget; Yellow box = adjust at each event ( = settings for events under low light)

  • Zoom = 200%
  • Double = checked
  • Frame Rate = 20,000 fps (for maximum horizontal resolution or reduce to i) improve aspect ratio, ii) increase exposure time, iii) decrease data transfer)
  • Frame Height = 2048 (or reduce to reduce data transfer size if lens cannot zoom in enough remove dead space)
  • LuxBoost = light multiplier. Increase if the iris is fully open, the gain raises above 120 and the image is too dark. Decrease if the gain is below 60.
  • AGC = Auto-Gain Control
  • Brightness = This number controls the threshold level for the AGC control. It tells the software how bright it should try to make the image by adjusting the gain values.
  • Frequency = sets the number of times a second the AGC checks the light level to see if adjustment is necessary.
  • Auto-Iris = will trigger commands to open or close the iris in order to maintain the gain between the Min and Max values. Recommend to uncheck and always run with the iris fully-open.

note: More on Gain Control Tools.

Timestamps

Synchronize to GPS Time

External Sync (ES) Plug-in Procedure - To correlate image frames to transponder times, both systems should be synced to the same time base.

note: The first camera to load in FinishLynx is assigned the role of Master camera. Internal time synchronization will adjust the time-base for other cameras.