Update Firmware
Operation of the Block Sensor and Command Center is controlled by software written on a microchip, known as firmware. Occasionally, you need to update your firmware.
To know when to update your firmware, click Help from the menu bar and select About. The About ReacTime window appears and lists the version number of the ReacTime firmware you are operating. Now, go to the website and check for the most currently released version of the ReacTime firmware. Then, follow the steps below.
- a. Connect the Block Sensor or the Command Center to the computer COM port using the ReacTime Serial Cable provided with your software.
- b. If the Block Sensor or Command Center is connected to the AC supply, disconnect it. Turn the unit OFF.
- c. Run the ReacTime Championship Software.
- d. Click Hardware. A drop-down list appears. Click Options. The Options window appears.
- e. Click the Serial tab. Click the Serial Port drop-down list and select an available COM port. If you are unsure which COM port to select, choose the first one that appears on the drop-down list. Click OK.
- f. Click Hardware on the menu bar. Select Update Firmware from the drop-down list. A Power window appears, instructing you to: "Turn off the ReacTime Unit, unplug power cord, and press OK." The Open window appears.
- g. Select the correct firmware image file (Block Sensor = bs.img, Command Center = cc.img), and then click Open. Wait while the unit updates.