Mounting Instructions: overview
Before you can start training with your ReacTime Training or Championship System, you must first mount the unit to a starting block. This chapter explains how to mount a ReacTime Unit to a variety of starting blocks.
ReacTime Unit mounting components
A ReacTime Unit includes the mounting components pictured here (see Figure 4).
Figure: Overview
Figure: Overview
- a. Block Sensor
- b. Securing screw
- c. Thumbscrews
- d. Mounting Plate
- e. Loudspeaker
- f. Wingbolts and washers
note: Not pictured are Mounting Clamps secured to Mounting Plate by flathead screws.
Figure 4: ReacTime Unit mounting components
Before you Begin
You need set of starting blocks before proceeding with these instructions. Depending on the starting block type, you may also need a Phillips head screwdriver.