Training System Software: overview
This chapter describes how to use ReacTime Training Software with a ReacTime Training System. The ReacTime Training Software allows you to analyze, store and print reaction time data downloaded from the Block Sensor.
note: If you do not purchase a ReacTime Training Software license, you may install the software in demo mode. Demo mode allows you to make certain updates to your Block Sensor. For demo software installation instructions, refer to Step 1: in this chapter. Then, refer to Step 8: for firmware update instructions, and to Step 9: to learn how to change your Block Sensor’s audio and language files.
This chapter assumes you have already followed the mounting instructions in Chapter 1, and that you know how to practice starts with your ReacTime Training System (Chapter 2).
note: For more information on using ReacTime Training System Software, you can also refer to the help file that comes with the software. To access the help file, run the ReacTime Training Software, click Help from the menu bar and choose Contents.
Before you begin
Before following the instructions in this chapter, you need:
- a ReacTime Training System properly mounted to a starting block (see Chapter 1).
- an IBM compatible PC with one available COM port.
- the two ReacTime Training Software floppy disks that came with your ReacTime Training System. (If you need to purchase a license, call Lynx customer service at 1-800-989-LYNX to obtain a serial number before proceeding with these instructions. If you do not want to purchase a software license, follow the instructions in Step 1: to install the software in demo mode.)
- the Serial Cable that came with your ReacTime Training System.