Blank BOOT light, red ON light
A red ON light with the BOOT light off means the camera has power but hasn't been switched on. Press the power button on the back once and the boot sequence starts.
On a Vision-series camera with the internal battery option, the ON light slow-flashes red instead of staying solid: the camera is off and the batteries are charging. The fix is the same, press the power button.
How to fix it
Turn the camera on
- Press the power button once. The BOOT light goes solid red for about 15 seconds while the camera boots, then flashes amber while it waits for FinishLynx
- Running on the internal battery with no external power? Press and hold the button instead
- To have the camera turn on by itself whenever it gets power, including PoE, turn on Auto-Boot (Vision-series only): once the camera has loaded, open Camera Settings, Setup tab, set Auto-Boot on (near the bottom of the tab) and click OK
- If Auto-Boot is already on and the camera still only starts from the button, the camera needs looking at by Lynx: submit an RMA
Good to know
With Auto-Boot on, a camera with internal batteries only charges when external power is applied and the camera has been turned off. To turn it off, hold the power button for more than 4 seconds, or use Shutdown in FinishLynx (Hardware Control: right-click the camera's Power field, then Power | Shutdown).
If the power button doesn't turn the camera on
- In this rare case you can still power the camera through the Aux power port: find the male mini-XLR port on the back of the camera
- Touch its top two pins at the same time with something metal (a key, screwdriver or paper clip) to jump them. The camera turns on
- Once the camera loads, set Auto Boot to On in Camera Settings, Setup tab. It then turns on by itself as soon as it gets PoE power, so you won't need the button
- To have the power button itself repaired, submit an RMA and send the camera in
Good to know
To charge the internal batteries, plug in PoE or Aux power with the camera off: the ON light slow-flashes red during the 10-hour charge and turns solid red when it is done. See the manual's Power Management page.
Send it in for repair
Start an RMA. The portal walks you through what to include and where to ship it.