Can't control remote iris
Start by reading the lens model printed on the side of the lens: the Iris Type FinishLynx needs depends on it. Then check the cable path, and swap parts to find out whether the camera, the Remote Positioner or the lens is at fault.
How to fix it
Set the Iris Type for your lens
- Open Camera Settings and click the Setup tab
- Set Iris Type to match the lens
- 2.8-10mm lens (common on Vision and Vision PRO): P-Iris
- 8-48mm lens (common on Vision): Normal
- 12.5-75mm lens (common on Vision PRO): Normal
- Click OK and try the Open Iris and Close Iris buttons again
Check the cable path
- The lens cable runs either straight from the lens to the Remote Control port on the back of the camera, or from the lens to the Remote Positioner and from the positioner's other port to the camera
- With a positioner in the path, bypass it: plug the lens cable straight into the back of the camera
- If the iris works now, the positioner or its cable is the problem: see Remote positioner or cable damaged
- If it still doesn't, the fault is in the camera or the lens
If the buttons click but the iris doesn't change (F-mount lens)
Clicking with no change means the command reaches the lens motor but the iris itself isn't moving. On an F-mount lens with a mechanical iris that is nearly always one of these two things:
- Close the lens iris by hand before you mount the lens
- Check that the small iris tab inside the camera's F-mount is in the correct position
Swap parts to find the fault
- If you have a second camera, put this lens on it. If that camera controls the iris, the lens is fine and the original camera is the likely fault
- If you have a second lens, put it on this camera. If this camera controls that lens, the original lens is the likely fault
If nothing remote works (positioner, zoom, focus and iris all dead)
- That points to the link between the camera and the positioner or lens. With no iris control the image overexposes in bright sun and only improves as the light fades
- Confirm the Iris Type (Setup tab) and that Auto Iris is checked (Camera Settings | Parameters)
- Bypass the positioner as above, then put the same positioner and lens on another camera. If everything works there, the camera's Remote Control port is the likely fault: submit an RMA and send the camera in to Lynx
- Test the lens on the other camera too. Include it in the RMA only if it also fails there
- Until it's fixed, raise the frame rate (Camera Settings | Parameters) to darken an overexposed image
The Position & Lens Controls page of the Online Manual shows the cable connections and the remote control icons. A camera or lens that fails these swaps needs a repair.
Send it in for repair
Start an RMA. The portal walks you through what to include and where to ship it.