Camera or positioner won't mount securely
Before assuming a mounting part is broken, check how it is fitted. The clamp's reversible brass stud has to go in the right way up, a Remote Positioner rocks until the camera's weight is on it, and a tripod needs its mounting plate in place.
If a stud or bolt has actually snapped, use the button below to ask about a replacement part.
How to fix it
Fit the brass stud in the camera clamp (pole or board mounting)
- Loosen the small knob
- Push the silver button
- Drop the stud into the hex hole with the 3/8-inch threads facing up
- Fasten the clamp to something that won't vibrate or move
If the Remote Positioner feels loose
A positioner that rocks with no camera on it is normal. Once the camera is mounted and its weight is on the positioner, it should not rock like that.
If the camera won't lock onto the tripod
- On the Lynx tripod the camera sits on a mounting plate that clicks into the geared head. Pull back the lever at the top of the geared head to release the plate
- Tighten the plate to the bottom of the camera by turning its screw with a flathead screwdriver, then click the plate into the geared head
- These steps are in the EtherLynx Vision Camera Setup QSG
- Check whether you're using a quick-release plate, and that the tripod's mounting plate is in place
- For an IdentiLynx on an older tripod, a missing tripod mounting plate is the first thing to check. The camera's bottom screw hole should still fit the tripod once the plate is in place
- If it still won't lock, use the button below
For where and how high to mount the camera, see the manual's Camera Mounting page, and use the Lens Calculator to pick a focal length for that spot.
Talk to Lynx Support
Tell the team what you’re seeing and what you’ve already tried. They’ll follow up by email or phone.
Related resources
- EtherLynx Vision Camera Setup QSG — Guide · PDF