No sound from speaker
A sound problem on the electronic gun system takes one of a few forms: the gun is too quiet, the speaker works but gives no gun sound, no sound at all, a quiet headset, or a dead megaphone microphone. Follow the section that matches.
How to fix it
If the gun sound is too quiet
- Turn up the volume on the speaker itself (on the Electronic Start Plus speaker, the Line In knob)
- The wheel on the base of the gun only sets the headset microphone volume, so it won't make the gun louder
- Check that the short aux cable labeled "Connect to Speaker" is seated in the speaker: the AUX port on the megaphone speaker, or the Line In port (with the aux adapter) on the Electronic Start Plus speaker
If the speaker works but there's no gun sound
When the microphone plays through the speaker (and the gun may even start FinishLynx), the speaker is fine and the gun's audio isn't reaching it.
- Check the "Connect to Speaker" aux cable is plugged in at the speaker, as above
- Check the dial on the gun is set to 1 (beep) or 2 (gunshot)
- On a PS78 gun, unplug the gun cable from the base of the gun and check that the four pins in the port are intact
- A bent, broken or missing pin means the gun needs a repair: submit an RMA
- If the pins are intact, the gun cable needs a repair: submit an RMA and send it in to Lynx
If there is no sound at all
- Check that the battery is charged
- Charge the speaker's battery between meets
- On the megaphone speaker, push the battery pack's power plug all the way into the pack: a red light shows when it is fully in
- Play a different audio source through the speaker
- If it plays, the fault is the gun or the gun cable: go through the section above
- If nothing plays, the fault is the speaker
If the gun's headset is too quiet
- Adjust the volume with the small wheel on the base of the gun
If only the megaphone microphone is dead
- If the gun sound works but the megaphone's voice microphone doesn't, the microphone can be replaced: submit an RMA and send the speaker in to Lynx
Good to know
If you can't tell which part has failed, send the whole start system (gun, gun cable and speaker) in to Lynx so every part can be checked.
Send it in for repair
Start an RMA. The portal walks you through what to include and where to ship it.