Transmitter not charging

A transmitter charging problem shows up one of three ways: the charging LED never comes on, the transmitter appears charged but only works while plugged in, or it won't turn on at all. Follow the path that matches.

How to fix it

Know what the LED means

  • The LED next to the charging jack is orange while the battery is charging and solid green when charging is complete
  • A full charge from empty takes about 1.5 hours
  • Press the ON/OFF button once to see the battery level as a percentage
  • Three beeps after a signal, "Lo" on the display or a blinking red LED mean the battery is low: charge it as soon as possible

If the charging LED does not come on at all

  1. Use the charger that came with the system: the Lynx 12 V power supply, part 8L-PS. If you're not sure which charger is right, ask Lynx
  2. If the LED still doesn't come on with the right charger, the transmitter needs a repair or replacement: submit an RMA and send it in

If the transmitter only works while plugged in

This includes a battery that reads 000 and never climbs while the LED shows green. The battery or the charging circuit has likely failed.

  1. Replace the transmitter, or have Lynx repair it
  2. As a stopgap, power it from a 9 V battery with one of these 9 V battery cable connectors

If it won't turn on, or freezes with the display on

  1. Charge it for at least 1.5 hours on the Lynx charger, then try again
  2. If it still only gives a beep with nothing on the display, or it freezes mid-meet, the transmitter needs a repair

Send the transmitter in and Lynx will tell you whether a repair or a replacement makes more sense. The LinkGate EncRadio & DecRadio manual covers the battery and charger in detail.

Send it in for repair

Start an RMA. The portal walks you through what to include and where to ship it.

Submit an RMA

Related resources