Operate the Competition
- a. Fire Recall Starter: Confirm that the Command Center and all Block Sensors are powered on and the LCD is visible in all screens.
- b. Fire Recall Starter: Confirm that the lane numbers indicated on the Block Sensors are correct.
- c. Fire Recall Starter: Note that the LCD on the Command Center indicates the number of Block Sensors configured in the top left corner.
- d. Fire Recall Starter: Press the Start button on the Command Center once to enter Standby phase.
- e. Official Starter and Recall Starter: Hear in the Headset a single beep, indicating Standby phase. This tone is not relayed over the athletes’ Loudspeakers. The Official Starter’s microphone and athlete Loudspeakers are now enabled.
note: The microphone will stay active until two seconds after the gun is fired.
- f.
Official Starter: Bring the athletes to their blocks.
- g. Official Starter: Bring the athletes to the Set position.
- h. Fire Recall Starter: Press the Start button again to enter the Active phase.
- Official Starter: Hears a double-beep in the Headset, indicating a “Set” tone. Again, this tone is not relayed over the athletes’ Loudspeakers.
At this point, if the gun is not fired within three (3) seconds, a warning tone (rapid warning beeps) sounds. If the gun is fired after the warning tone, reaction times will be recorded, but no traces will be stored. To avoid this, the Fire Recall Starter may return the system to the “Standby” phase by pressing the Start key again.
- i.
Official Starter: Fire the gun.
Reaction times are displayed on each Block Sensor’s LCD immediately after a start. Note: As soon as the Fire Recall Starter presses the Start key again, these times disappear from the LCD’s.
If a false start (as defined by IAAF rules) occurs, the Official Starter and the Fire Recall Starter hear three strong tones. Note: The ReacTime Championship System emits an electronic gun tone automatically if the Fire Recall setting is turned on. The electronic gun tone will sound from all of the athletes’ Loudspeakers in the event of a false start. (Please refer Appendix B at the back of this manual to learn how to enable the Fire Recall option.)
If the Line Printer is connected to the Command Center printer input, reaction times for all of the athletes are printed automatically just after the gun.
System errors and warning tones The Starters may hear certain warning tones during a competition. This section describes the various warning tone indications.
- Repeated beeps: If the Starter hears repeated beeps, a Block Sensor or cable connection failure is indicated. The Starter should check all Block Sensors that they are correctly configured with the proper lane number, and that all cables are connected.
- Single warning tone: The controls on the Block Sensors are locked out to prevent athlete interference. Any attempt to disconnect the Block Sensor is signaled by a warning tone in the Starter’s Headset.
note: When the Block Sensors are in “Athlete Lockout Mode,” you can get out of this mode by holding the Delete key and the Off/On key simultaneously for 5 seconds and the Block Sensor will turn off.
- Three strong beeps: A false start is indicated by three strong beeps in the Starter’s Headset.