Configure the Command Center
After you have configured the Block Sensors, configure the Command Center by following these steps.
- a. Turn on the Command Center by pressing and holding the OFF/ON key.
- b. Change the lane number configuration.
- Press the Menu key once.
- Press the up and down arrow keys until you arrive at the Main Menu | System screen.
- Press the Menu key once. The System Menu | Number of Lanes screen appears.
- Press the Menu key once. Scroll to choose the correct number of lanes.
- Press the Menu key again to return to the ReacTime | Ready to Arm screen. The upper left corner of the Command Center LCD shows the number of lanes being used.
- c. Review the Command Center’s default settings. The list below describes the default settings that were programmed into your Command Center. If you need to change any of these settings, please refer to Appendix B at the back of this manual.
- Network Type: Wired
- Remote Volume: 6
- Headset Squelch: 5
- Headset Volume: 5
- Fire Recall: No
- Detection: - Active Time: -0.3 From Gun - Threshold: Normal
- Gun Sensor - Type: Norm. Closed - Armed In Ready: Yes
- d. When you have finished configuring the Command Center, continue on to Chapter 5.