Keys
- A. Menu (scrolls forward to the next menu screen)
- B. Back arrow (goes back to the previous menu screen)
- C. Start (triggers the start sequence)
- D. Up arrow (scrolls up to the options within a menu)
- E. Down arrow (scrolls down to the various options within a menu)
- F. Off/On (turns the Command Center off and on)
- b. Connect the Signal Input Cable attached to the Gun Sensor to the appropriate input on the Command Center (label 6 in Figure 38).
- c. Connect the Command Center Cable to the Block Sensor in Lane 1 (label 3 in Figure 37) and the appropriate input in the Command Center (label 3 in Figure 38).
- d. Connect a Headset Cable to the Official Starter’s Headset (the Headset with two ear pieces) and connect the other end to of the Headset Cable to the appropriate input on the Command Center (label 7 in Figure 38).
- e. Connect a Headset Cable to the Recall Starter’s Headset (the Headset with one ear piece) and connect the other end of the Headset Cable to the appropriate input on the Command Center (label 4 in Figure 38).
- b. Optional set up
If you have purchased any of the following items, follow the instructions in this section to connect them.
Extra gun cable
You may want to connect extra gun cable to your Championship System to give the Official Starter greater range.
- a. Connect the Signal Input Cable to the extra gun cable.
- b. Connect the other end of the Signal Input Cable to the input on the Command Center (label 5 in Figure 38).
- c. Connect a Gun Sensor to the open end of the gun cable.
Line Printer
Please consult the manufacturer’s operation manual that came with your Line Printer if you have specific questions not covered in this section.
- a. Connect the printer cable to the Line Printer.
- b. Connect the Line Printer power supply to the Line Printer.
note: The Line Printer can also run with battery power.
- c. Connect the open end of the printer cable to the input on the Command Center (label 9 in Figure 38.