Power On the Block Sensors
You can run the Block Sensors on their own battery power or using the Command Center power supply.
- a. (Optional) Run the Block Sensors with battery power
Your ReacTime Championship System comes with all eight Block Sensors and the Command Center fully charged. When not uploading trials to a computer using the Championship Software, a fully charged ReacTime Championship System lasts about:
- 2 hours when used with a wireless system running a race about every five minutes.
- 8 hours when used with a wired system running a race about every five minutes.
Therefore, depending on whether you are using a wireless or wired ReacTime Championship System, you can run a system on battery power for either 2 or 8 hours, respectively. Please refer to Chapter 5 to learn how to recharge the Block Sensors and Command Center. To run the Block Sensors with battery power:
- a. Turn on all Block Sensors by pressing and holding the OFF/ON key (label F in Figure 37).
- b. Each LCD turns on and looks like Figure 39.
Figure: Power On the Block Sensors
Figure 39: ReacTime | Ready to Start screen using fully charged batteries
- b. (Optional) Run the Block Sensors with the Command Center power supply
If you have access to power at the track using a wired system, you can use electrical power rather than relying on the battery charge. With a wired system, you can power all eight Block Sensors using a single Command Center power supply.
- a. Connect the Command Center power supply to the appropriate input (label 1 in Figure 38).
- b. Plug the power supply into an electrical outlet. All eight Block Sensors are powered automatically.
- c. Turn on all Block Sensors by pressing and holding the OFF/ON key (label F in Figure 37).
- d. Each LCD turns on and looks like Figure 40.
Figure: Power On the Block Sensors
Figure 40: ReacTime | Ready to Start screen using power supply