Re-Attach the Block Sensor (if necessary)
If you removed the Block Sensor to re-arrange the Mounting Clamp configuration, re-attach the Block Sensor by tightening the securing screw into the topmost, centered hole at the top of the Mounting Plate. Your properly mounted ReacTime Unit looks like Figure 21 below. This completes the Mounting Instructions for your ReacTime Unit.
To learn how to begin training with your ReacTime Training System, continue to Chapter 2. To learn how to set up your ReacTime Championship System, skip to Chapter 4.
Figure: Re-Attach the Block Sensor (if necessary)
Figure 21: Properly mounted ReacTime Unit