(Optional) Use an External Gun Sensor
Follow the instructions in this section if you are using an external Gun Sensor instead of the Start Button with the Virtual Starter.
- a. Connect the Gun Sensor to the Block Sensor
Remove the Start Button connected to the end of the Signal Input Cable, and replace it with the Gun Sensor. Plug the Signal Input Cable into the input on the Block Sensor (see Figure 22).
- b. Change Block Sensor settings
After you have connected a Gun Sensor to the ReacTime System, you must configure the Block Sensor to work with the type of Gun Sensor you are using.
note: When using a Gun Sensor, it is recommended that you set the Intervals menu in the Block Sensor to Manual. Follow the instructions in Step 3: earlier in this chapter to set the Intervals menu to manual.
- a. At the Main Menu | Training screen, press the Menu key.
- b. Scroll through the Training Menu sub-menus using the up or down arrow keys until you arrive at the Training Menu | Gun Source screen. Press the Menu key once.
- c. If you are using a normally closed Gun Sensor, scroll to the Gun Source | Norm. Closed screen. If you are using a normally open Gun Sensor, scroll to the Gun Source | Norm. Open screen. Once you have made your selection, press the Menu key once to return to the ReacTime | Ready to Start screen.