Power and Turn On the Block Sensor
note: ReacTime Block Sensors are shipped completely charged, and will work for about eight hours. If you are eager to start training with your ReacTime Training System right away, skip this step and go directly to Step 3:. Follow the instructions in this section to learn how to re-charge the Block Sensor.
You can power your ReacTime Training System using the power supply provided or using built-in rechargeable batteries.
- a. Run ReacTime using the power supply provided
Plug one end of the power supply into the input on the side of the Block Sensor (see Figure 22) and plug the other end into a power outlet. Turn on the Block Sensor by pressing and holding the OFF/ON key until the LCD reads, ReacTime | Ready to Start.
Figure: Power and Turn On the Block Sensor
Figure 24: ReacTime | Ready to Start screen using power supply
- b. Run ReacTime using built-in batteries
You may run the ReacTime Training System using built-in rechargeable batteries when you are not using the power supply. A ReacTime Training System running a trial every 4-5 minutes can last for 8 hours on batteries. (Note: If you are downloading trials from the Block Sensor onto a computer using the ReacTime Training Software, the batteries last less than eight hours.)
Make sure the power supply is unplugged from the power outlet. Then, turn on the Block Sensor by pressing and holding the OFF/ON key until the LCD turns on and reads, ReacTime | Ready to Start.
Figure: Power and Turn On the Block Sensor
Figure 25: ReacTime | Ready to Start screen using fully charged batteries
- c. Recharge the Block Sensor
When the Battery Mode Indicator on the LCD becomes mostly unshaded, the Block Sensor needs to be re-charged. You need about four hours to completely re-charge the Block Sensor.
To recharge the Block Sensor, turn the unit off. With the Block Sensor turned off, reconnect the power supply. The LCD reads, "Fast Charging" and after 3 hours changes to "Slow Charging." After about four hours, the LCD dims completely. You will know that the Block Sensor is fully charged when you turn the unit back on and notice that the Battery Mode Indicator is completely shaded (as in Figure 25).