Configure ReacTime Training Software
Follow the instructions in this section to set up the ReacTime Training Software to work with the Block Sensor.
- a. Connect the Serial Cable you received with your ReacTime Training System between the Block Sensor and an available COM port on the back of your computer. (Note: For a complete diagram of the Block Sensor inputs, please refer to Figure 22.)
- b. Start the ReacTime Training Software by selecting it from the Windows Start menu. A screen appears containing the ReacTime Training System Software menu bar. The Menu bar contains the following icons (see Figure 30):
- New Workout
Figure: Configure ReacTime Training Software
- Open Workout
Figure: Configure ReacTime Training Software
- Save Workout
Figure: Configure ReacTime Training Software
Figure 30: ReacTime Training S ystem Software menu bar icons
- c. Click Hardware and choose Options from the drop-down list. The Options window appears.
- d. Click the Serial tab. Click the Serial Input drop-down list and select the COM port that the Serial Cable is connected to. Click OK.