Customize ReacTime Training System
This section describes how to customize your ReacTime Training System by changing the language files in the Training Software or by changing the audio files used by the Virtual Starter on the Block Sensor.
- a. Change the language files in the Training Software
The menus and dialog boxes used in the Training Software are currently available in several languages. Follow the steps below to load an existing language file.
- a. Run the ReacTime Training Software. Click File from the menu bar and choose Options.
- b. Click the General tab and choose the language you want from the Language drop-down list.
- c. Click OK and then exit ReacTime Training Software. The next time you run the software, it displays the new language you chose.
note: To create your own language files, contact Lynx support.
- b. Change the Virtual Starter’s audio files
You can customize your own recordings of the "On Your Marks" and "Set" commands (for example, in the coach's voice or in another language) and upload them to the Block Sensor. (Note: The gun sound cannot be edited.)
To customize the audio files, you need:
- software that can create an 8khz 8 BIT mono WAV file (such as Windows Sound Recorder)
- a sound card in your computer
- a microphone
Then, follow these instructions:
- a. The ReacTime Training directory contains two files: onmark.wav and set.wav. Go to the directory on your computer called "reactime." Double-click the "training" folder to view the onmark.wav and set.wav files.
- b. Rename the existing files before recording new files so that they can be restored if necessary. For example, you can rename them “onmark_old.wav” and “set_old.wav.” When you record new files, do not exceed 2 seconds in length for each file.
- c. Re-record new files using sound recorder software and save them to this directory, naming them “onmark.wav” and “set.wav,” respectively.
- d. After recording new files, connect the Block Sensor to the computer COM port using the ReacTime Serial Cable provided.
- e. Click Hardware. A drop-down list appears. Click Options. The Options window appears.
- f. Click the Serial tab. Click the Serial Input drop-down list and select the COM port the Serial Cable is connected to. Click OK.
- g. Select Hardware from the menu bar of the ReacTime Training Software and choose Load Audio. This connects the computer to the Block Sensor and updates the audio files you have just recorded that are used for the start sequence. Wait while the files load. A Confirm window appears.
- h. If you want to load the new audio files you just created onto another Block Sensor, replace a different Block Sensor with the one you just updated and then click Yes. If you do not want to load the audio files you just created onto another Block Sensor, click No. The new audio files are loaded onto your Block Sensor.