Update Firmware
Operation of the Block Sensor is controlled by software written on a microchip, known as firmware. Occasionally, you may need to update your firmware. To find out what version of firmware you are currently running, turn on the Block Sensor and follow these steps:
- a. From the ReacTime | Ready to Start screen, press the Menu key once.
- b. Press the up and down arrow keys until you arrive at the Main Menu | About screen.
- c. Press the Menu key again. Press the up and down arrow keys until you arrive at the About | SW: [version number] screen.
Now, go to the Lynx website (http://www.finishlynx.com) and check for the most currently released version of the ReacTime firmware. If you are running an old version of firmware, follow the steps below to update your Block Sensor.
- a. Connect the Block Sensor to the computer COM port using the Serial Cable provided.
- b. If the Block Sensor is connected to the power supply, disconnect it. Turn the Block Sensor OFF.
- c. Run the ReacTime Training Software.
- d. Click Hardware. A drop-down list appears. Click Options. The Options window appears.
- e. Click the Serial tab. Click the Serial Port drop-down list and select the COM port the Serial Cable is connected to. Click OK.
- f. Click Hardware on the menu bar. Select Update Firmware from the drop-down list. A Power window appears, instructing you to: "Turn off the ReacTime Unit, unplug power cord, and press OK." The Open window appears.
- g. Select the firmware image file (bs.img), and then click Open. Wait while the unit updates.