Flashing Link lights
On an EtherLynx 2000 (5L200), flashing Link lights and no boot usually mean dirty or oxidized contacts on the internal DC power harness. Cleaning them often restores normal booting, and you can do it yourself.
How to fix it
Clean the DC harness contacts
- Remove the front panel screws and the front of the camera, then disconnect the three ribbon cables behind the front plate
- Remove the back panel screws
- Slide the camera out of the enclosure
- Unplug the DC harness and clean its contacts with a lubricating contact cleaner. Unplugging and re-plugging the harness several times also cleans the contacts, even without cleaner
- Reassemble the camera in reverse order, then power it on and check that it boots
If it still won't boot
- The boot now starts but stops partway: see Boot stops partway (2000 camera)
- The BOOT light stays solid red: see 2000 camera
- Vision-series camera (5L500 and up)? The lights at its network port are ordinary activity lights. Read the ON and BOOT lights on the back instead: FinishLynx not finding camera
- Vision-series camera with an error on screen: Boot error on screen
- Rather not open the camera, or it still won't boot after cleaning: send it in
Send it in for repair
Start an RMA. The portal walks you through what to include and where to ship it.