Image is blurry and can't focus
Where to start depends on whether you can get a sharp image at any distance. Sharp at some distances but not others, or focus that drifts: on the 8-48mm lens that is usually the four silver screws on the back of the lens. Nothing sharp at any distance: the CS-C mount adapter.
How to fix it
Which is it?
- Sharp at some distances, not others, or the focus drifts: start with the silver screws (8-48mm lens)
- Sharp during the day, soft as it gets darker: also the silver screws. As the light fades the iris opens wider and the depth of focus shrinks, which shows up the problem
- Nothing is sharp at any distance, like frosted glass: check the CS-C mount adapter
- A lens other than the 8-48mm won't focus and the adapter is right: see "Another lens" below
First, two quick checks
- The lens is screwed in properly, all the way to its stopper
- The lens isn't over-tightened. Stop turning as soon as it reaches the stopper
8-48mm lens: tighten the silver screws
Four small silver screws on the back of the 8-48mm lens loosen over time, often after shipping or a repair. That changes the distance between the lens and the sensor, so zoom and focus drift, Auto-Focus fails and the image won't stay sharp at some distances. The Fix Out-of-Focus Lens video shows the fix.
- Remove the lens from the camera
- Find the four small silver screws on the back of the lens
- Tighten all four. Don't overtighten: the screws strip easily
- Refit the lens, stopping as soon as it reaches the stopper
- Try to focus again
Nothing sharp at any distance: check the CS-C adapter
- The CS-C adapter is a 5mm ring between a C-mount lens and a Vision or Vision PRO camera. A C-mount lens (the 8-48mm, the 12.5-75mm and other C-mount lenses) needs exactly one; a CS-mount lens (the 2.8-10mm) needs none
- 2.8-10mm lens (Vision or Vision PRO): the adapter must not be installed
- 8-48mm lens (Vision): the adapter must be installed
- 12.5-75mm lens (Vision PRO): the adapter must be installed
- Two rings stacked together push the lens too far from the sensor and nothing focuses at any zoom or focus setting. With no ring the lens sits too close to the sensor to focus
- An adapter can stay screwed onto the back of a lens when it moves to another camera, so one camera ends up with none and another with two. Two rings stuck together can be unscrewed from each other with pliers
- The CS-C Mount Adapter User Guide lists which lenses need it on each camera
Another lens that still won't focus with the right adapter
- The lens assembly may have been knocked out of position. Check the lens for loose screws and tighten them, without overtightening
- If it still won't focus, it needs a repair: submit an RMA and send the camera in to Lynx
Once the lens can focus
- Focus in 2-D EasyAlign mode until the Focus Helper number above the alignment view is as high as you can get it, or use Auto-Focus (FinishLynx 13.10 or later): see Align the camera on the finish line
- Focus with the iris wide open (check AEC in 2-D mode, or uncheck Auto Iris while you focus) so the image stays sharp as the light fades
Good to know
Stop turning as soon as the lens reaches its stopper: tightening past it damages the lens in a way that can't be repaired.
Send it in for repair
Start an RMA. The portal walks you through what to include and where to ship it.
Related resources
- Fix Out-of-Focus Lens video — Video · YouTube
- CS-C Mount Adapter User Guide — Guide · PDF