Not detected after a reset

A hard reset clears the camera name and IP address that FinishLynx uses to find an IdentiLynx. The camera's web page may still open, but FinishLynx can't find the camera until those settings are put back with a camera discovery utility.

How to fix it

Restore the camera name and IP address

  1. Download the discovery utility for your camera from the Software page (Drivers & Utilities): IP-Toolbox for the SR, SR-2 and HRS, or IQfinder for older models such as the B91. The model is on the camera's label
  2. Install it, then right-click it and select Run as administrator, with the camera connected
  3. Get the camera name and IP address to enter from Lynx: use the button below with the camera's model and serial
  4. In the utility, select the camera and set its name and IP address to those values. The camera reboots
  5. Restart FinishLynx and boot the camera

If the utility can't find the camera at all, see No network switch activity.

Good to know

Before resetting an IdentiLynx on purpose, check with Lynx first, and write down the camera's name, IP address, subnet mask and gateway from the discovery utility (with FinishLynx closed, so it doesn't load the camera): you'll need to enter them again after the reset.

Talk to Lynx Support

Tell the team what you’re seeing and what you’ve already tried. They’ll follow up by email or phone.

Contact Support