No network switch activity
No link or activity on the switch port when the camera is plugged in means the camera is not communicating over the network at all. Start by inspecting the camera's Ethernet port, then take the switch out of the path. A camera that worked and then stopped mid-meet goes through the same checks.
How to fix it
Check the Ethernet port
- Inspect the Ethernet port on the back of the camera for corrosion or debris on the pins
- If there is any, clean the port with isopropyl alcohol on a Q-tip and let it dry fully before reconnecting
Test the camera straight to the computer
- Connect the camera to the FinishLynx computer through the power injector supplied with it, instead of through the PoE switch, using an Ethernet cable you know works. Without the switch, the injector is what powers the camera
- If the camera does not power on at all, see Won't power on from PoE
- If it boots straight to the computer but the switch still shows no link from it (with another port and cable tried), the camera's network port is the likely fault: submit an RMA and send it in
Test with the discovery utility
- Download the camera finder for your model from the Software page (Drivers & Utilities): IP-Toolbox for the IdentiLynx SR, SR-2 and HRS, or IQfinder for older models such as the B91, B95 and IDL031. The model is on the camera's label
- Run it with the camera connected
- If the camera is listed, it is on the network and its settings need checking. Continue with Network switch activity
- If it is not listed with a known-good cable and the supplied injector, the camera has no network activity and needs repair. If your other IdentiLynx and VeriLynx cameras connect fine on the same setup, the camera itself has failed
If there is still no network switch activity
This needs a repair: submit an RMA and send the camera in to Lynx.
Older IdentiLynx (IDL031)
The IDL031 is the older black IdentiLynx with a manual 5-50 mm lens. If one isn't found by IQfinder even after a full reset, it has an internal hardware failure that Lynx can't repair. Ask Lynx sales about trading it in toward a current IdentiLynx through Get a Quote on finishlynx.com.
Send it in for repair
Start an RMA. The portal walks you through what to include and where to ship it.