Won't power on from PoE
When an IdentiLynx or VeriLynx won't power on, first find out whether the camera or its power source is at fault. Test it on the power injector that came with it, connected straight to the FinishLynx computer.
How to fix it
Test with the supplied injector
- Plug the injector's power supply into power
- Connect an Ethernet cable from the FinishLynx computer to the injector's In port
- Connect the camera's Ethernet cable from the injector's Out port to the camera (the IdentiLynx SR-2 & HRS Setup QSG shows the hookup)
- If the camera powers up and boots this way, the camera is working and the switch or power box is the likely problem: go to the next section
- If it doesn't, skip to "If it won't power on from the injector either"
If it works on the injector but not on your switch or power box
- Lynx recommends a PoE+ gigabit switch for the IdentiLynx SR-2 and HRS
- A switch or third-party PoE box that runs a Vision camera or an older IdentiLynx may still not power a newer model such as the SR-2
- Power the camera from its supplied injector (the injector's In port can take a cable from your switch), or move it to a PoE+ port
- Check the switch's total PoE budget as well as the per-port rating. Allow up to 18.72 W for each newer IdentiLynx, 15.4 W for each older IdentiLynx, and up to 30 W (802.3at PoE+) for each Vision camera
- The figures are on the datasheets: IdentiLynx SR-2, IdentiLynx HRS
- VeriLynx: the V30 takes PoE+ (802.3at), the V60 standard PoE (802.3af). See the VeriLynx V30 and VeriLynx V60 datasheets
- For choosing a switch and cabling, see Camera won't power from the switch
If it won't power on from the injector either
- Try another Ethernet cable you know works
- Check the camera's Ethernet port for corrosion or debris, and clean it with isopropyl alcohol on a Q-tip if needed, letting it dry fully
- If the camera still won't power on from the supplied injector connected straight to the computer, it is almost certainly a hardware fault and needs a repair: send the camera in to Lynx
Send it in for repair
Start an RMA. The portal walks you through what to include and where to ship it.
Related resources
- IdentiLynx SR-2 & HRS Setup QSG — Guide · PDF
- IdentiLynx SR-2 — Guide · PDF
- IdentiLynx HRS — Guide · PDF
- VeriLynx V30 — Guide · PDF
- VeriLynx V60 — Guide · PDF