Camera won't power from the switch

EtherLynx Vision-series cameras take their standard power from 802.3at PoE+, up to 30 W per port. A switch or injector that gives only 15.4 W per port (standard PoE) can't power a Vision PRO X, so the camera boots on its PoE+ injector but not on that switch.

The IdentiLynx SR and SR-2 need 802.3at PoE+ as well, so an older standard-PoE box is the first thing to check when a new IdentiLynx shows no link or drops off after a few minutes.

How to fix it

Check the switch

  1. Check the switch's PoE rating per port on its label or datasheet. It needs to say 802.3at or PoE+.
  2. If it doesn't, use a PoE+ switch, or power each camera from its own PoE+ injector.
    • The injector's In port can take a cable from the switch, so the switch stays in the data path.
  3. Check the cable. Don't send PoE over copper-clad aluminum (CCA) cable. See Choosing a cable.
  4. If the camera still won't boot on a known PoE+ source, follow the BOOT light steps in FinishLynx not finding camera.

Several cameras on one switch

  • Check the switch's total PoE budget as well as the per-port rating. Allow up to 30 W for each Vision-series camera and up to 18.72 W for each IdentiLynx (15.4 W on older IdentiLynx models), add them up and compare with the budget on the label.
  • A PoE+ switch is the standard setup in current Lynx packages. It replaces the PoE injectors: the cameras, the FinishLynx computer and any other computer (a LynxPad computer, for example) each plug into their own port on the switch.
  • The power figures are on the camera datasheets, for example the Vision PRO X Datasheet and the IdentiLynx SR-2 Datasheet.

IdentiLynx on the same network

  • The IdentiLynx plugs into the network switch, not into the photo-finish camera. Connect the Vision camera, the IdentiLynx and the FinishLynx computer to the same switch. Both cameras run on PoE, so no AC power is needed at the finish line.
  • Lynx recommends a PoE+ Gigabit switch and a Gigabit network card in the computer when you add an IdentiLynx.
  • If the switch has enough power and the IdentiLynx still drops, see Camera dropping randomly. For an IdentiLynx that won't power up at all, see Won't power on from PoE.

Related resources