Camera dropping randomly
An IdentiLynx or VeriLynx that drops out of FinishLynx mid-meet, or a minute or two after it loads, has lost its connection to FinishLynx. Work through these checks in order.
How to fix it
Make sure only one FinishLynx is looking for cameras
- On every other computer on the network running FinishLynx, set Hardware Type to None (File | Options | General) and restart FinishLynx
- A camera can only connect to one FinishLynx at a time. A second FinishLynx that is looking for cameras will keep trying to give it a new IP address
Check power, cable and port
- Note whether the camera is powered by its PoE injector or by a PoE switch port, then try another injector or switch port and another Ethernet cable
- Check the camera's Ethernet port for corrosion or debris on the pins, and clean it as in No network switch activity
- If a pin is corroded or the port is damaged, the camera needs a repair: submit an RMA. See also Camera body or ports damaged
- With several cameras on one PoE switch, check that the switch's total PoE budget covers them all: up to 18.72 W for each newer IdentiLynx (15.4 W for older models) and up to 30 W for each Vision camera
- If it started after the camera got wet, let it dry out fully before testing again, and protect it from rain from then on. See Rain and weather protection
Check the network load
- For the IdentiLynx SR-2 and HRS, Lynx recommends a PoE+ gigabit switch and a gigabit network card on the FinishLynx computer
- Add one IdentiLynx at a time, and raise the resolution or frame rate in small steps while watching network traffic
- Keep Parameters | Quality below about 80: at 80 or 85 and up the frames barely compress, the data rate exceeds what the camera can send, and frames are dropped
- For cross country and road races it is rarely necessary to go over 10 fps
- If the video drops frames at high resolution or frame rate, see the IdentiLynx cache card on the FinishLynx Other Settings page
Check the FinishLynx computer
- Work through the computer-side checks in Camera dropping randomly: IP conflicts, adapter power saving and Energy Efficient Ethernet, Wi-Fi on the same subnet, and Windows 11 computers on the network
Good to know
Boot the IdentiLynx last, after the EtherLynx cameras appear in Hardware Control. Then if the IdentiLynx drops and has to be rebooted, the other cameras aren't interrupted.