Image is blurry and can't focus

When auto-focus keeps zooming in and out and the picture never gets sharp enough to read bibs, the lens has usually been knocked out of place, typically from a fall. On an IdentiLynx HRS or SR you can push the lens back into place yourself; first make sure the lighting isn't the problem.

How to fix it

Check the lighting first

  1. If the image is also very dark, fix the brightness before anything else: see Black image when capturing
    • A very dark image makes focusing hard, so a camera that is dark and blurry is often only dark

Run auto-focus

  1. In the Hardware Control window, hold Ctrl + Shift and click Focus Near or Focus Far
  2. To focus by hand, click Focus Near or Focus Far for small steps, or Shift-click or Ctrl-click for bigger steps
  3. On a manual lens, turn the focus ring on the lens instead
  4. Refocus whenever you change the zoom: IdentiLynx lenses are varifocal and don't hold focus through the zoom range
  5. If the lighting is right and auto-focus still never settles, re-seat the lens (next section)

Re-seat the lens (IdentiLynx HRS and SR)

  1. Watch the IdentiLynx HRS/SR Lens Repair video before you start
  2. Open the live image in FinishLynx so you can see the focus as you work
  3. Remove the screw on the top white cover
  4. Loosen the two small hex screws by the lens
  5. Slide the lens module forward or back until the image is sharp
    • If it was knocked loose, pressing it firmly back into place with your thumb is often enough
  6. Retighten the screws and replace the cover
  7. Run auto-focus again to confirm it now settles

Good to know

The re-seat is for IdentiLynx HRS and SR cameras only. On another model, check that manual focus still works, and if it doesn't, the camera needs a repair.

If it still won't focus

This needs a repair: send the camera in to Lynx.

Send it in for repair

Start an RMA. The portal walks you through what to include and where to ship it.

Submit an RMA

Related resources