Capture-and-read FinishLynx setup

Multi-user mode lets one computer capture image while a second computer evaluates the results at the same time. Both must be on the same network with access to a shared Event Directory; the Windows side (addresses, sharing, mapping) is in Multi-computer networking.

How to fix it

Set up the evaluate computer

  1. Install FinishLynx from the Software page with your existing serial number (shown under Help | About on the capture computer). No extra serial is needed.
  2. Open FinishLynx, go to File | Options, and on the General tab set Hardware Type to None.
  3. Click OK and restart FinishLynx. It will never try to load the cameras.
  4. Leave Run as administrator unchecked on its FinishLynx shortcut.
  5. Give it a static IP on the timing network: 192.168.0.15 with subnet mask 255.255.255.0 (the capture computer is 192.168.0.5), in the same Workgroup as the other computers, not a Domain.
  6. Turn on Network Discovery and File and Printer Sharing, allow C:\Lynx\Lynx.exe through the firewall, and map the capture computer's shared meet folder as a network drive (Reconnect at sign-in).
  7. Point the Event Directory (Event | Options) and the Input and Output Directories (File | Options | Database tab) at that mapped drive, and point your meet software at the same folder.
  8. On Windows 11, apply the print fix before the first meet: Slow start or printer warning.

During a meet

  1. On the capture computer, create a new event and save it. The evaluate computer cannot open the event until it has been saved at least once.
  2. Wait for the start signal. It triggers an autosave that stores the start time in the event file.
  3. On the evaluate computer, open the same event. It opens in reader mode.
    • A temporary .evr file is created for the evaluate computer, which checks for new image every five seconds.
  4. Evaluate results on the evaluate computer as images come in.
  5. Save the event on the evaluate computer. This merges the .evr file back into the main .evn file without overwriting the capture computer's work.
  6. Pull the results into your meet management software as usual.

To add or fix splits on the evaluate computer

  1. Go to LapTime | Options…, click New and choose From Image.
  2. Restart FinishLynx and check the device status reads Running.

If it needs the latest start times (Time Trial mode)

  • Go to File | Reload. This saves, closes and reopens the event with the latest data the capture computer has stored.

If it opens an event but says "no image found"

Windows inherited permissions are the cause. FinishLynx creates image files in C:\Lynx\Temp on the capture computer and moves them to the shared Event Directory on save, and they can keep the non-shared permissions of the temp folder. The same cause shows as the .evn file appearing on the evaluate computer while the .i01 image file does not.

  1. On the capture computer, share C:\Lynx\Temp (or the whole C:\Lynx folder) with read and write permissions.
    • The evaluate computer never uses these folders directly. Sharing them makes the image files moved out of Temp inherit the right permissions from now on, so you no longer re-share the folder after each race.

Manual page: Multi User Mode.

Good to know

Only one computer should crop image. If the capture computer crops image, any cropping done on the evaluate computer is lost.