Error writing .LIF file

The "error writing .LIF file" message (error 3002) appears after saving an event. FinishLynx can't write to the Output Directory: it has no permission for the folder (when it is on another computer), has lost access to it, or the folder doesn't exist.

How to fix it

Check the Output Directory

  1. Click File | Options | Database tab
  2. Check that the Output Directory points at the right folder
    • On another computer: confirm FinishLynx has permission to write to it and that the network connection is active
    • Doesn't exist: point the Output Directory at a valid folder
  3. If it is a shared folder or mapped drive on another computer, open it in File Explorer from the FinishLynx computer. If it won't open, re-share the folder or remap the drive: Windows updates can reset these connections
  4. If the network location keeps dropping, point the Output Directory at a local folder on the FinishLynx computer and share that folder with the meet management computer instead
  5. Save the event again. File | Save writes the .lif along with the event; File | Save LIF writes only the results file

If no .lif file is written at all

  1. Click File | Options | Database tab
  2. Check that Data Source is set to Files and Write LIF File is On, with the other LIF settings at their defaults
  3. Set the Output Directory to the folder your meet or results software reads from, then save the evaluated event again and look for the .lif
    • The .evn file FinishLynx saves for each race is the event and image, not the results

For sharing a folder between computers, see Multi-computer networking. The settings are described on the Database options page of the manual.