Connection to FieldLynx

NetExchange is the bridge between your meet management software and the FieldLynx devices. It reads the field event start list files the meet manager exports, sends them to FieldLynx over the network when asked, and writes the marks FieldLynx sends back as .lff files.

How to fix it

Check NetExchange is running properly

  1. Plug the NetExchange USB hardware key into the computer running NetExchange and leave it there. NetExchange won't run without it
  2. Right-click NetExchange and choose Run as administrator
  3. Check Help | About shows the current NetExchange, 3.25, from the Software page, and update FieldLynx to 1.96 too. An old version on either side can leave FieldLynx stuck on Connecting
  4. The products your license enables show in green, and the Port Number defaults to 1950

Set the directories

  1. Set the Event Files directory to the folder where your meet management software exports the field event start list files
  2. Set the Results Files directory to the folder where FieldLynx results should be written
    1. These are usually the same folder

Check the network

  • FieldLynx and NetExchange must be on the same network with IP addresses on the same subnet. That may mean setting a static IP address on both the NetExchange computer and each FieldLynx device
  • NetExchange can also run on the FieldLynx computer itself, with the key plugged into it. That is the way to use full FieldLynx on one laptop with no network

Connect FieldLynx

  1. In FieldLynx, go to Options | Preferences, Database tab: Network (connect), the NetExchange computer's IP address and the port NetExchange shows
  2. Click Load Schedule. The FieldLynx-side steps, firewall and offline use are under Connection to NetExchange

The NetExchange quick start guide shows the main window and its default settings. If NetExchange won't open at all, see App does not open.

Related resources