Connecting the gun
An electronic gun doesn't use a start sensor. The red (RadioLynx, normally open) and white (wired, normally closed) sensors are only for a traditional pistol; with an electronic gun, the gun cable carries the start signal.
How to fix it
Connect the gun cable
- Put batteries in the gun first (and charge the speaker if you have the Electronic Start Plus)
- Plug the 4-pin end of the gun cable into the base of the gun
- Plug the short aux cable labeled "Connect to Speaker" into the speaker: the AUX port on the megaphone speaker, or the Line In port (with the aux adapter) on the Electronic Start Plus speaker
- Plug the headset into the audio jack on the bottom of the gun
Connect the start signal
- Wireless (RadioLynx): remove the red start sensor from the RadioLynx transmitter input cable and plug the input cable into the gun cable connector labeled Start Output
- The same input cable connects a Microgate HiLink transmitter; Lynx supplies one if your HiLink came without it
- Wired: connect the male end of the start cable to the connection box (or the DB15-to-XLR cable) and the female end to the gun cable's Start Output at the speaker
Set FinishLynx
- Wired: open Camera Settings | Inputs tab and set the start sensor to Open, because the electronic start is normally open
- RadioLynx: set the Inputs tab to None, then set the Port and Start Sensor on the RadioLynx tab, as in RadioLynx not working
Test
- Set the dial on the gun to 1 for a beep or 2 for a gunshot sound
- Fire the gun and check that FinishLynx receives the start
The Lynx Electronic Start System Demo shows the setup; the wiring diagrams are in the Electronic Start System QSG and the Electronic Start Plus QSG.
Related resources
- Lynx Electronic Start System Demo — Video · YouTube
- Electronic Start System QSG — Guide · PDF
- Electronic Start Plus QSG — Guide · PDF