RadioLynx not working
When RadioLynx stops starting the clock, check the plug-in and the RadioLynx settings in FinishLynx first. On a new computer or after reinstalling FinishLynx, these settings have to be made again.
How to fix it
Check the RadioLynx plug-in
- Click Help | About and check that RadioLynx is listed
- If it isn't listed, or the RadioLynx port settings are grayed out, see RadioLynx port settings grayed out and Option grayed out or missing
Check the RadioLynx settings
- Open Camera Settings | Inputs tab and set the wired start sensor to None. The wired and wireless starts are separate connections
- On the RadioLynx tab, set Port to the connection the receiver uses:
- RadioLynx Port: external receiver plugged into the round RadioLynx connector on a Vision camera (round black plug)
- Camera Back: external receiver on the camera's serial port and 12 V output (for example EtherLynx 2000+, Fusion and PRO)
- Internal: Vision camera with Internal RadioLynx (the short antenna screwed onto the gold threaded connector on the camera back)
- Connection Box: external receiver plugged into the serial port and 12 V output of a Connection Box, with the Connection Box linked to the camera's Connection Box port by the connection box cable
- Under Setup, select Start Sensor with Id 000, which matches a transmitter at its default setting (Channel 0, signal type STA). On a fresh install it is set to None, and no start comes through until you change it
Check the receiver connection
- Make sure the receiver's plugs are fully seated, including the red 12 V power plug on cameras that use it
- If a wire has pulled out of the receiver's serial connector, see Antenna or cable damaged
- An external receiver can also be tested on a Connection Box: plug it into the Connection Box's serial port and 12 V output, link the Connection Box to the camera's Connection Box port with the connection box cable, and set Port to Connection Box
Check these
- If you use automatic capture, Capture Method on the Capture tab is set to Automatic
- With more than one timer-enabled camera, check the settings on every camera
- If loading an event shows "All start sensors failed to arm", see "All start sensors failed to arm"
If it is still not working
- If the transmitter beeps with the start, see Transmitter beeps with start
- If the transmitter doesn't beep with the start, see Transmitter doesn't beep with start
- If it only works near the camera, see Only works close to the camera; if it misses some starts, see Misses some starts
- To recover a race that ran without a start, see Recover a race after a missed start
Watch Configure FinishLynx for RadioLynx Start Signals, and keep the RadioLynx Wireless Start Troubleshooting QSG handy for the step-by-step paperclip test.
Good to know
FinishLynx LITE has no Start Sensor setup option or Id: RadioLynx is always the start sensor, so on the RadioLynx tab just select the port the receiver is plugged into (LITE vs full).
Related resources
- Configure FinishLynx for RadioLynx Start Signals — Video · YouTube
- RadioLynx Wireless Start Troubleshooting QSG — Guide · PDF