Transmitter doesn't beep with start

If the transmitter doesn't beep when the gun fires, when you tap the sensor or when you press the signal button, one of three parts is at fault: the transmitter, its input cable or the red start sensor. The paperclip test finds which in a few minutes.

How to fix it

Find the faulty part

  1. Press the signal button on the transmitter
    • If it beeps, the transmitter works and the problem is the input cable or the sensor
    • If it doesn't beep, and especially if the display is blank, see Transmitter not charging
  2. Run the paperclip test: see Paperclip test
  3. If the cable fails, check where the wires join the banana plugs
    • Pull the black and green connector covers up the wire. Each wire is held by a tiny screw
    • A wire that has come apart from its plug is the most common cable fault
  4. If the transmitter and cable pass but the sensor doesn't, replace the start sensor. It may have got wet or been damaged

With an electronic gun

  1. The transmitter input cable plugs into the gun cable's Start Output, with no sensor. If the gun fires but the transmitter doesn't beep, the gun cable is the usual cause: see Using wireless RadioLynx

Good to know

If the transmitter beeps on every start but FinishLynx gets nothing, its settings may have been changed: see Transmitter beeps with start.

If a part failed

A transmitter that fails the paperclip test needs a repair: send it in to Lynx. A start sensor is replaced, not repaired.

Send it in for repair

Start an RMA. The portal walks you through what to include and where to ship it.

Submit an RMA