Transmitter beeps with start

If the transmitter beeps when you shoot the gun, tap the sensor or press the signal button, the transmitter is doing its job: the start is being lost between the receiver and FinishLynx. Work through these checks in order.

How to fix it

Check the RadioLynx settings in FinishLynx

  1. In the Hardware Control window, open the camera's settings and go to the RadioLynx tab
  2. Confirm Port matches where the receiver is plugged in
    • Internal: a Vision camera with Internal RadioLynx (the short antenna on the RADIO LYNX connector on the camera back)
    • RadioLynx Port: an external receiver on the round RadioLynx connector of a Vision camera
    • Camera Back: an external receiver on the camera's serial port and 12 V output
    • Connection Box: an external receiver on the Connection Box's serial port and 12 V output, with the Connection Box linked to the camera's Connection Box port by the connection box cable
  3. Confirm Setup is set to Start Sensor with Id 000

Check the receiver's connection

  1. Make sure the receiver's plugs are fully seated, including the red 12 V power plug where it has one
  2. As a test, move the receiver to another connection, for example a Connection Box, and set Port to match

Check the DIP switches

  1. The four frequency switches are under the black cap on the right side of the back of the transmitter, and under the black cap on the receiver
  2. Each switch, labeled 1 to 4, is either up or down. The setting must match on the transmitter and the receiver
  3. With Internal RadioLynx, the receiver's setting is the Frequency on the RadioLynx tab: 0 is down (off), 1 is up (on), left to right. See Changing frequency

Check the transmitter settings

  1. Turn the transmitter off and on. While it boots it should show: CHA, 000, -L-, TYP, Sta, 000, then beep once
    • Id 000 in FinishLynx means channel 000 and signal type Sta. If the display shows another channel or type, hold an arrow key while turning the transmitter on to set it back, or pick the matching Id in FinishLynx

If it still gets no start

  1. Reset the camera settings: go to Help | System Info…, check Delete camera default file (.cdf), click OK and restart FinishLynx, then set up RadioLynx again from the RadioLynx QSG
  2. Swap one part at a time with a working system: the receiver, then the transmitter, until the faulty one shows itself
  3. Meanwhile, time with the wired start cable that came with your system: see Recover a race after a missed start

A wire that has pulled loose from the input cable or the receiver cable is covered in Antenna or cable damaged. The RadioLynx Troubleshooting Guide has the same checks.

Send it in for repair

Start an RMA. The portal walks you through what to include and where to ship it.

Submit an RMA

Related resources