Changing frequency

The RadioLynx frequency is set with four DIP switches, and the transmitter and every receiver must use the same setting. To stay clear of another system nearby, pick a setting that system isn't using and set it on all of your units.

How to fix it

Choose a code

  1. Each switch is 0 (down, off) or 1 (up, on). Reading switches 1 to 4 left to right gives a four-digit code
    • For example, switches 1 to 3 off and switch 4 on is 0001
  2. Pick one of the 16 codes that is different from the code you are on now and from any other system you know of nearby
    • For example, move from the default 0001 to 0010
    • There is no single best code. 0000 (all down) and 1111 (all up) are the two ends of the band (434.650 MHz and 433.900 MHz), so if you suspect interference, try one of those to get as far from it as possible

Set the transmitter (EncRadio)

  1. Remove the right-most black cap on the back of the transmitter
  2. Set the four DIP switches to your code

Set every receiver to the same code

  1. External receiver (DecRadio): remove the black cap on the front and set its four DIP switches to the same code
  2. Internal RadioLynx (Vision camera): in FinishLynx, open Camera Settings | RadioLynx tab and select the same code under Frequency
    • The number in brackets after the code, for example 0001 (47), is the equivalent HiLink setting
  3. Set every receiver you use. Receivers on the same code are all started by the one transmitter, for example two cameras

Test before the meet

  1. Press the signal button on the transmitter and check that FinishLynx receives a start
  2. If the transmitter beeps but FinishLynx still gets no start, see Transmitter beeps with start

The RadioLynx Wireless Start manual page and the Internal RadioLynx QSG show the Frequency setting.

Good to know

The frequency is separate from the transmitter's Id (its channel and signal type, 000 by default in the RadioLynx tab).

Good to know

Running a primary and a backup RadioLynx pair at the same time? Give each pair its own frequency to reduce the risk of a missed signal.

Related resources