Antenna or cable damaged

A worn antenna cover or a loose wire in a cable is a common repair after a few seasons. Most of the time you can keep timing while you wait for the part.

How to fix it

If the antenna or its rubber cover is damaged or missing

  1. Ask Lynx for a replacement antenna. Replacements have to match the connector: the transmitter antenna and the short antenna on the camera's RADIO LYNX connector are different parts
  2. Until it arrives, the antenna can be used without its rubber cover. If it no longer reaches the camera, switch to the wired start cable for the meet (below)
  3. If the antenna mount on the transmitter spins freely, the connection inside is broken: see Only works close to the camera

If a wire is pulling out of the receiver's serial connector

  1. Look at which wire has come loose. The blue wire isn't used, so a loose blue wire doesn't matter
  2. If the red wire has come out, push it back into its pin and secure the cover so it can't pull out again
  3. On a Vision-series camera you can skip the serial adapter: plug the receiver into the camera's RadioLynx port, then in Camera Settings | RadioLynx tab set Port to RadioLynx Port

If a wire came loose from the transmitter input cable

  1. Slide the black or green cover up the cable and refit the wire under the small screw inside the banana plug
  2. Test it with the paperclip test: see Paperclip test

Keep the meet running on the wired start

  1. Connect the wired start cable with the white wired start sensor (pistol) or to the electronic gun's Start Output
  2. In Camera Settings | Inputs tab set the start sensor to Closed (pistol) or Open (electronic gun), and set the RadioLynx Port to Off

Replacement antennas and cables come from Lynx: use the button below and say which part you need.

Talk to Lynx Support

Tell the team what you’re seeing and what you’ve already tried. They’ll follow up by email or phone.

Contact Support