Only works close to the camera
RadioLynx is rated for about 2 km with a clear line of sight between the antennas, so on a track with an open infield distance alone should never be the problem. A start that only works near the camera points first to the antennas: the wrong one, a missing one, or a broken antenna connection inside the transmitter.
How to fix it
Check the antennas
- The long, flexible antenna goes on the RadioLynx transmitter
- On a Vision camera with Internal RadioLynx, the short black antenna (about 10–15 cm) screws onto the RADIO LYNX connector on the camera back. It is meant to be short
- The Internal RadioLynx QSG shows the connector
- Don't use the electronic start speaker antennas on the camera
- Screw each antenna on fully, but don't overtighten
- Use the antennas supplied by Lynx. A replacement must match the connector and spec (see the note below)
If the camera antenna is missing
- Check under the foam in the camera case
- If it isn't there, Lynx can supply a replacement antenna
Check the transmitter antenna mount
- Gently twist the base of the transmitter's antenna
- If the mount spins freely, the antenna connection inside the transmitter is probably broken. This needs a repair: submit an RMA and send the transmitter in to Lynx
Check the signal path
- Keep a clear line of sight between the transmitter and receiver antennas. Trees, houses or buildings between them can cut the range to 100–200 m
- Look for walkie-talkies, wireless TV cameras or other radios nearby. If you suspect interference, see Changing frequency
- After each signal, check the RadioLynx Packet number in the status bar (bottom left): a low number means a strong, clear signal, and a high number (up to 16) means the signal took many tries to get through. The RadioLynx Performance Indicator video shows it
Very long courses (rowing, canoe, kayak)
An extended-range RadioLynx transmitter (part MG-ENC204, the 500 mW EncRadio 500) has more than four times the range of the standard transmitter: over 9 km in normal conditions against over 2 km. Ask Lynx about it if your start is too far away for the standard one.
Until it's fixed, use the wired start
- Connect the wired start cable, with the white wired start sensor (not the red RadioLynx sensor) for a pistol
- In Camera Settings | Inputs tab, set the start sensor to Closed for the standard normally closed sensor, or Open for an electronic gun
- In the RadioLynx tab, set Port to Off
If the start still drops out at a distance, see Misses some starts.
Good to know
Replacement antennas use a TNC connector on the transmitter and an SMA connector on the internal receiver.
Send it in for repair
Start an RMA. The portal walks you through what to include and where to ship it.
Related resources
- Internal RadioLynx QSG — Guide · PDF