Misses some starts

If RadioLynx works most of the time but misses some starts, recover the race first, then find the weak link. A quick clue: if the signal button on the transmitter always starts FinishLynx, the radio link is fine and the misses are between the gun (or the sensor) and the transmitter.

How to fix it

Recover the missed race

  1. Press Repeat on the transmitter before the next start. It resends the last start with its original time
  2. For other ways to add a start afterward, see Recover a race after a missed start

Check the transmitter input cable

  1. Slide the black and green covers up the cable (use pliers if they're tight)
  2. Tighten the small screws that hold the wires in the banana plugs
    • This is the most common cause of starts that come and go
  3. Don't tape the cable tightly to a tripod

Check the start sensor (pistol starts)

  1. Run the paperclip test: see Paperclip test
  2. If the transmitter and cable pass but blowing into or tapping the sensor gives no start, replace the start sensor
  3. If the sensor got wet, set it aside to dry for a few days to a week; don't take it apart
    • Then tap the top several times and make sure every tap registers. If it still misses, replace it

Charge the transmitter

  1. Three beeps at power-on or after a signal mean the battery is low. Recharge it fully before the meet
    • Press the ON/OFF button once to see the battery level as a percentage

Electronic gun: don't use the sound sensor

A sound sensor placed in front of an electronic gun's speaker is unreliable. Connect the gun to the transmitter instead.

  1. Lynx Electronic Start: remove the sensor and plug the transmitter input cable into the gun cable's Start Output. See Connecting the gun
  2. Gill Halo: plug Gill's adapter cable in where the sound sensor normally connects, or use the start output on the speaker. See Gill Halo
  3. Secure the plug so it can't fall out

Check the antennas and the signal path

  1. Check that the right antennas are screwed on fully and that the transmitter's antenna mount doesn't spin: see Only works close to the camera
  2. Keep a clear line of sight between the transmitter and the camera
  3. Look for walkie-talkies, wireless TV cameras or other radios near the start or the camera. To get away from them, change the DIP-switch frequency on the transmitter and receiver: see Changing frequency
    • After a start, the RadioLynx Packet number in the status bar (bottom left) shows how many tries the signal took, up to 16. A high number means a weak link

Internal RadioLynx camera: test with an external receiver

  1. Connect an external RadioLynx receiver (DecRadio) to the serial port on the camera back
  2. In Camera Settings | RadioLynx tab, set Port to Camera Back
  3. If the misses stop, the internal receiver is the likely cause. This needs a repair: submit an RMA and send the camera and the transmitter in to Lynx together
    • If you can't send the camera in before your next meets, keep timing with the external receiver on the Camera Back port until the internal receiver is repaired

If the sensor fires on its own in the wind

Lynx doesn't sell a windscreen: shield the sensor with any object, such as a box or a plastic container. To clear a false start, arm the event (Ctrl+A): the clock goes back to 0:00. See FinishLynx receiving multiple starts.

Send it in for repair

Start an RMA. The portal walks you through what to include and where to ship it.

Submit an RMA