Gill Halo
With a Gill Halo, no start or an "All start sensors failed to arm" message is nearly always the connection at the Halo or a FinishLynx start setting. Check the connection first, then the settings for the way you connect: through RadioLynx or wired to the camera.
How to fix it
Check the connection at the Halo
- Make sure the connector is fully seated in the port on the Halo gun.
- Confirm it's in the timing port, not the audio port.
- One port is for the timing system, the other is for audio.
- With a Gill speaker, you can connect the timing system (the wired start cable or the RadioLynx transmitter input cable) to the Start port on the back of the speaker instead.
Connect the Halo to RadioLynx
- Don't hold a start sensor up to the Halo or its speaker. A sound sensor is unreliable with an electronic gun and misses starts.
- Remove the red start sensor from the RadioLynx transmitter input cable (the cable with the banana plugs).
- Connect the Halo to that cable with Gill's adapter cable. It may have come in the Halo kit; if not, get it from Gill.
- In FinishLynx, open Camera Settings, click the RadioLynx tab, set Port to where the receiver is connected and Setup to Start Sensor.
- On the Inputs tab, set the start sensor to None unless you also use a wired start.
- Fire the Halo and check that FinishLynx receives the start.
Connect the Halo with the wired start cable
- Connect the start cable to the Halo's timing port, or to the Start port on the Gill speaker.
- In FinishLynx, open Camera Settings, click the Inputs tab and set the start sensor to Open.
- On the RadioLynx tab, set Port to Off.
If it still doesn't start
- "All start sensors failed to arm" when you open an event: "All start sensors failed to arm"
- RadioLynx: the Paperclip test tells you whether the transmitter and its cable are working.
- Wired: Two-minute sensor or cable test
- For the Halo itself, see the Gill Halo documentation.
Related resources
- Gill Halo documentation — Guide · PDF