Two-minute sensor or cable test

Two quick tests with an unfolded paperclip tell you whether the start sensor or the start cable is at fault. Have FinishLynx running with the camera on and an event open, so you can see each start come in.

No connection box? Run the same tests on the DB15-to-XLR cable plugged into the back of the camera.

How to fix it

Test 1, paperclip at the end of the start cable

  1. Unplug the start sensor from the end of the long start cable
  2. Put the paperclip across holes 1 and 3 in the cable end, then remove it
  3. A start means the cable, connection box and camera are working, so the sensor is the problem

Test 2, sensor straight into the connection box

  1. Bypass the long start cable: plug the sensor directly into the Start port on the connection box, or into the DB15-to-XLR cable on the camera
  2. Blow into the sensor or tap it sharply on your palm
  3. A start means the long start cable is the problem

If neither test gives a start

  1. Put the paperclip across holes 1 and 3 directly on the connection box Start port, or on the end of the DB15-to-XLR cable
  2. Still no start: check the Start Sensor setting on the camera's Inputs tab, as in FinishLynx not receiving start
  3. If the setting is right, the connection box or its cable may be at fault

False starts with no gun, the flex test

  1. Unplug the sensor from the end of the start cable
  2. Flex the cable along its length
  3. If false starts keep coming with no sensor attached, the cable has a short, for example from being spiked

Wet or waterlogged sensors

A sensor that has fully dried may give starts again, but it may not be reliable, so replacing it is recommended. Let it dry for several days without opening it, then fire several simulated starts in a row (blow into it or tap it sharply on your palm) and make sure every one registers.

If the sensor is the problem

  • Wired start sensors, such as the standard 3L400, can't be repaired: order a replacement, and consider keeping a spare
  • A normally closed sensor (the standard 3L400 with ready light) that starts the timer as soon as it's plugged in and won't re-arm has failed

To recover a race that ran without a start, see Recover a race after a missed start. The manual's Wired Starts page covers the Start Sensor setting.