FinishLynx not receiving start
When the gun fires (or you tap the sensor) and FinishLynx shows no start, the fault is in one of four places: the sensor, the long start cable, the connection box, or the Start Sensor setting on the camera's Inputs tab. These checks find which in a few minutes.
The same path applies to any contact-closure device on the Start port, such as a tape switch or an electronic gun: FinishLynx treats them all as a wired start.
How to fix it
Check the red light on the sensor
- The standard Lynx sensor is normally closed and its red light stays on the whole time it is connected. No light means no connection, or a failed sensor
- The label on the side of the sensor says whether it is normally closed (the common type) or normally open
Bypass the long start cable
- Plug the sensor straight into the Start port on the purple connection box, or into the DB15-to-XLR cable coming off the camera
- Blow into the sensor or tap it sharply on your palm. If FinishLynx now gets a start, the 500-foot start cable is the problem
Run the paperclip test
- Put an unfolded paperclip into holes 1 and 3 of the Start port on the connection box, or of the DB15-to-XLR cable
- Insert and remove it. That should trigger a start
- A start means the camera and connection box work, so the fault is the cable or the sensor: the Two-minute sensor or cable test tells you which
- No start: check the camera settings next
Check the camera settings
- Open Camera Settings | Inputs tab and set Start Sensor to match the sensor: Closed for the standard normally closed sensor, Open for a normally open sensor or an electronic gun. Click OK
- The manual page Wired Starts shows the dialog
- If you don't use RadioLynx, set the Port on the RadioLynx tab to Off so FinishLynx doesn't try to arm it
- Load the event again and repeat the paperclip test. If there is still no start, the connection box, its cable or the camera needs a look from Lynx
No connection box?
You don't need one: plug the DB15-to-XLR cable into the back of the camera, connect the start cable to it and put the sensor on the far end. FinishLynx LITE (Scholastic) setups don't use a connection box at all: see FinishLynx LITE vs full.
Not a wired start?
- A starter remote (RadioLynx) that stopped starting races: see RadioLynx not working
- An electronic gun on the wired start cable: see Using wired start cable
- To recover a race that ran without a start, see Recover a race after a missed start
Talk to Lynx Support
Tell the team what you’re seeing and what you’ve already tried. They’ll follow up by email or phone.