Using wired start cable
An electronic gun on the wired start cable is a normally open start, so the first thing to check is the Inputs tab. After that, the checks run from the camera back out to the gun.
How to fix it
Check the camera settings
- Open Camera Settings | Inputs tab and set Start Sensor to Open. Click OK
- The standard wired sensor is Closed; an electronic gun is the opposite, so a system that used a pistol before needs this change
Bypass the 500-foot start cable
- Connect the gun cable's Start Output to the connection box, or to the DB15-to-XLR cable from the camera, without the long cable
- Fire the gun. If the start now arrives, the 500-foot start cable is the problem
Prove the camera side with a paperclip
- Put an unfolded paperclip into holes 1 and 3 of the Start port on the connection box, or of the DB15-to-XLR cable, and remove it
- A start means the camera and box are fine, so the fault is in the gun or the gun cable. No start: recheck the Inputs tab, then see FinishLynx not receiving start
Check the gun and the gun cable
- Check both ends of the gun cable for damage, such as a snapped connector, and switch to a spare gun cable if you have one
- Carrying the gun by its cable is the usual cause
- On an older PS78 gun, unplug the gun cable from the base of the gun and check that the four pins in the port are intact
- A bent, broken or missing pin means the gun needs a repair: submit an RMA
- If the pins are intact, the gun cable needs a repair: submit an RMA and send it in to Lynx
If the gun starts the clock but the speaker is silent or quiet, that is a sound problem: see No sound from speaker. The wiring is in the Electronic Start System QSG.
Send it in for repair
Start an RMA. The portal walks you through what to include and where to ship it.
Related resources
- Electronic Start System QSG — Guide · PDF