Using wireless RadioLynx
With an electronic gun on RadioLynx, the start travels gun, gun cable, transmitter input cable, transmitter, receiver, camera. Press the signal button on the transmitter first: if that starts FinishLynx, the radio link and the settings are fine and the fault is in the gun or the gun cable.
How to fix it
If the signal button doesn't start FinishLynx either
- Transmitter beeps but no start arrives: see Transmitter beeps with start
- Transmitter doesn't beep: see Transmitter doesn't beep with start
If the signal button works but the gun doesn't
- Check both ends of the gun cable for damage, such as a snapped connector
- Carrying the gun by its cable is the usual cause, so avoid it
- If you have a spare gun cable, switch to it
- The transmitter input cable (with the banana plugs) unplugs from the gun cable and moves to the spare. If the spare fixes it, the old gun cable needs a repair: submit an RMA
- On an older PS78 gun, unplug the gun cable from the base of the gun and check that the four pins in the port are intact
- A bent, broken or missing pin means the gun needs a repair: submit an RMA
- If the pins are intact, the gun cable needs a repair: submit an RMA and send it in to Lynx
Keep timing while you fix it
- Use the wired start cable as a backup: see Using wired start cable
- To recover races that ran without a start, see Recover a race after a missed start
A gun that flashes but whose sound comes and goes usually has the same cable fault; for sound alone, see No sound from speaker. Starting with a Gill Halo instead of the Lynx gun? See Gill Halo.
Send it in for repair
Start an RMA. The portal walks you through what to include and where to ship it.