Initial connection

The Gill ultrasonic wind gauge is a standalone serial device: it connects to the FinishLynx computer over a 9-pin serial cable, and FinishLynx then runs it (start, reset, interval and reading requests). Most first-time problems come down to the wrong port on the gauge, the wrong serial settings, or the cable run.

The gauge's own instructions are in the Gill Ultrasonic Wind Gauge User's Manual.

How to fix it

Power the gauge

  1. The gauge runs on 4 x 3AA cells (about 20 hours of continuous use on fresh alkaline cells) or the 110–240V AC adapter.
  2. For a long cable run, use the AC adapter: the power draw is much higher over distance.

Use the right port on the gauge

The gauge has two ports on its left side panel, and using the wrong one is the most common mistake.

  1. INPUT/OUTPUT (RS422/RS485) is the one for FinishLynx. It is bidirectional, which is what lets FinishLynx start the gauge, set the interval and request readings.
  2. REMOTE (RS232) is output only, for large-character displays and scoreboards. FinishLynx can't control the gauge through it.

Connect the serial cable

  1. Under 12 m: plug the 9-pin D-Sub serial cable (male connector) into the INPUT/OUTPUT port and run it to the computer's serial port.
    • A computer without a serial port needs a USB-to-serial adapter. Note the COM port number Windows gives it.
  2. Over 12 m, up to 450 m: an RS232-to-RS485 converter is required to boost the signal, with terminators on the cable. Use the AC adapter in this setup.

Set up the Wind tab in FinishLynx

  1. Start FinishLynx and go to File | Options, Wind tab.
  2. Set Wind Module to Gill and Serial Port to the COM port the gauge is on.
  3. Set the serial settings to match the gauge: 9600 baud, 7 data bits, even parity, 1 stop bit.
  4. Click OK, then close and reopen FinishLynx.

Test the wind reading

  1. Open a new race for testing.
  2. Start it with a start sensor or a manual start.
  3. FinishLynx triggers the gauge, and the reading appears after the event's averaging interval (10 seconds for a 100M).

Good to know

The gauge is a Gill Athletics product: for its buttons, display, power or an internal fault, contact Gill Athletics.

Related resources