Wind Gauge Options

Options - Wind Tab

Figure: Wind Gauge

See the Wind Gauges section for details on how to configure and operate FinishLynx with a wind gauge.

Wind Module:* (drop-down)

Use the drop-down menu to select the wind gauge to be used.

note: Changes to this value only take place the next time FinishLynx is run.

Serial Port: (drop-down)

Sets the port used for the wind gauge. See Port Settings for more information.

Default Mode: (drop-down)

Default Mode selection sets the wind measurement parameters when a new event is created.

  • Manual Used when the operator triggers a wind measurement manually. The duration is configurable.
  • Custom Used when the wind measurement should be triggered by a start signal, but does not correspond to other preset options below. Both the start and duration are configurable.
  • 100M Preset Start (0.0) and Duration (10.0) for a 100m athletics race.
  • 200M Preset Start (20.0) and Duration (10.0) for a 200m athletics race. It is expected the operator will manually start the wind reading when the leader enters the straightaway. The value of 20.0 for Start ensures a wind reading will be retrieved if the operator forgets.
  • 100M Hurdles Preset Start (0.0) and Duration (13.0) for a 100m Hurdles athletics race.
  • 110M Hurdles Preset Start (0.0) and Duration (13.0) for a 110m Hurdles athletics race.

Start (free-text)

Defines the time from the start signal FinishLynx will send a command to the wind gauge to begin the wind measurement.

Duration (free-text)

Defines how long the wind measurement will last.

Reminder: (radio buttons)

When set to ON, FinishLynx will pop-up a dialog when a new event is created to remind the operator to check the wind gauge settings.

Warn If Offline: (radio buttons)

When ON, FinishLynx will pop-up a dialog if the wind gauge does not respond as expected. For the Lynx wind gauge, this is as soon as a problem is detected, for others, the warning will be after a failed attempt at retrieving a reading.

note: Warnings are never received while capture or alignment is enabled.