Solid green BOOT light

A solid green BOOT light means the camera is powered and loaded into a copy of FinishLynx. If it isn't in your Hardware Control window, another copy has it, because a camera connects to one FinishLynx at a time.

Look for another computer on the network running FinishLynx, or a second FinishLynx window on this computer.

How to fix it

Free the camera

  1. On every other computer on the network that runs FinishLynx, set Hardware Type to None (File | Options | General tab) and restart FinishLynx. Only the timing computer should look for cameras
  2. Make sure only one copy of FinishLynx is open on the timing computer
  3. Reboot the camera (unplug it and plug it back in) so it loads into your FinishLynx
    • If the BOOT light then stays at flashing amber, the camera is waiting for FinishLynx and the computer is holding it up. On a new computer especially, work through Flashing amber BOOT light

See where the camera went

  1. In FinishLynx, click Help | Find Cameras.... It lists every camera on the network that has an address, including ones that aren't in the Hardware Control list
  2. Select a Vision-series camera there and click Restart to reboot it from FinishLynx
    • A camera ends up loaded but unlisted when more than one network adapter was enabled while it booted, or over a poor connection such as Wi-Fi. Set Camera Network to the wired adapter and keep Wi-Fi off while the cameras boot

Two timing computers on one network

  • Give each computer a white list so it boots only its own cameras: Help | Find Cameras..., check Use White List, select the cameras and click Add. The manual's White List Management page has the details (it isn't available on the EtherLynx 2000)

If FinishLynx shows Error 129

  • Another device may be using the camera's address (one above the computer's: 192.168.0.6 on the standard setup). Remove or re-address it so the camera's address is free
  • In File | Options | General tab, set Camera Network to the static address you gave the camera adapter (192.168.0.5 on the standard setup)
  • The full steps are in Error 129