Vision series camera (SN >= 5L500)

On a Vision-series camera (serial number 5L500 and up), a BOOT light that stays solid red for more than a minute means the internal firmware flash drive has failed. Solid red for the first 15 seconds or so of every boot is normal.

The fix is a replacement flash drive that Lynx builds for your camera and loads with its firmware (it isn't interchangeable with other cameras), and you fit it yourself through the front plate. There may be a small fee.

How to fix it

Check it is a Vision-series camera

  • The model number is on the label on the bottom of the camera: 5L500 and up is a Vision-series camera
  • On an EtherLynx Pro, Fusion or 2000+ (5L300 to 5L420) a solid red BOOT light is the BIOS chip, not a flash drive, and the fix is different: see Pro, Fusion or 2000+ camera (5L300 <= SN <= 5L420)

Try this first, to get through the meet

  1. Remove the 4 screws on the outer corners of the front plate of the camera
  2. Take the USB flash drive off the board inside the camera
  3. Put the same drive into a different USB port, either inside the camera or on the rear of the camera
  4. Refit the front plate and screws, then boot the camera
    • If the BOOT light moves on to flashing amber, the camera is booting. This is a temporary fix until the replacement drive arrives

Get the replacement drive

  1. Request the drive with the button at the bottom of this page
  2. Have the lynx.cm# files from C:\Lynx on a computer that has booted this camera ready to attach (lynx.cm1, lynx.cm2 and so on). Lynx builds the drive for your camera from these files

Fit the new drive

  1. Remove the 4 screws on the outer corners of the front plate
  2. Take the old USB flash drive off the board inside the camera
  3. Insert the replacement drive in its place
  4. Refit the front plate and screws, then boot the camera

After the new drive is in

  • BOOT light flashing amber but FinishLynx doesn't find the camera: the swap worked, and the computer is holding things up. Work through the checklist for a Flashing amber BOOT light
  • Still solid red: open the front plate again, seat the new drive in a different USB port (inside or on the rear) and boot again
  • The camera loads, then shows "Error aligning a camera", goes red and reboots over and over: the drive may need to be rebuilt for your camera. Use the button below
  • Solid red BOOT light, then the ON light turns red and the Ethernet lights go dark: a different hardware fault, not the drive. The camera needs a repair: submit an RMA
  • Rather not open the camera? Send it in and Lynx fits the drive: submit an RMA

Good to know

Don't plug the camera's flash drive into a computer. It holds a proprietary format that a computer can't read, and doing so can corrupt it. For the same reason the firmware can't be emailed as a file.

Good to know

Replacement drives are a newer, smaller type than the original purple drives and haven't shown the same failures, so a spare isn't usually needed.

Talk to Lynx Support

Tell the team what you’re seeing and what you’ve already tried. They’ll follow up by email or phone.

Contact Support