No white background after alignment
In a photo-finish image the background is the finish line itself, repeated thousands of times. On the white line you get a white background with black lane stripes.
A dark background with white lines means the camera is looking just in front of or behind the line. White in only some lanes means it is off swivel (rotated slightly).
How to fix it
Put the camera back on the line
- In the Hardware Control window, select the camera and start 2-D EasyAlign mode
- Vision-series cameras have EasyAlign; older cameras use 1-D Line Scan mode
- Line the green vertical line up on the front half of the white finish line, near its front edge, not in front of or behind the line
- Move the camera with the tripod head or geared head, or with the Remote Positioner controls
- Check the result in 1-D Line Scan mode: the background should be white and the lane lines black across the full width of the track
If only some lanes are white, level the swivel
- Level the camera with a standard level, or with the Level Indicator (an option on Vision-series cameras): adjust the swivel until the level icon is green
- Not sure which way it is rotated? Pan the camera slowly through the finish line in the direction the athletes run and watch which part of the image goes white first
- Top first: rotate the top of the camera away from the finish line
- Bottom first: rotate the bottom of the camera away from the finish line
- Re-align on the line as above
Check the finish line itself
- Lane markings: the finish line needs black squares where the lane lines cross it; these become the black lane stripes. Paint them with flat paint, or as a last resort use small pieces of tape, but not shiny plastic tape, which can look white in bright sun
- Clutter behind the outer lanes: stand up or zip-tie a white board in line with the finish line, just beyond the last lane, to give those lanes a plain white background
If it was right before the meet and wrong in the results
- The camera has usually been moved by wind or soft ground. Don't stand the tripod on a table
- In wind or on soft ground, center the camera on the finish line rather than its front edge, so it can move a little and still stay on the white
- Moving the camera closer is fine as long as lane 1 is visible from the knees or waist up and the top of the head is visible in the outer lanes. A taller tripod reduces one athlete blocking another
Watch the alignment tutorial, or the video on aligning a Vision camera with EasyAlign and a Remote Positioner. The Finish Line Prep page of the Online Manual shows how the finish line should look, and the Camera Orientation page shows an off-swivel image. The Setup Basics training session covers alignment at about the 33-minute mark.
For the full setup, from mounting and leveling to focus and a test capture, see Align the camera on the finish line.
Related resources
- alignment tutorial — Video · YouTube
- Setup Basics training session — Video · YouTube